The cuts made with the utility knife are your guidelines as to where to stop chiselling.
How to fit a door handle and latch.
Use the sharp chisel and the hammer to chisel out a hole for the latch.
Before you can fit a door handle to a new door you will first need to mark regions to be drilled and cut.
Also chisel inside the hole for the latch to fit.
The normal height for fitting a mortice latch is a metre up from the floor around 3 feet but you can either match existing handle heights ask the client how high they want them or check the drawing schedule to find out which height to drill the handles.
Tape measure pencil flat drill bit for wo.
This video is about how to fit a door latch and door handle in an interior door.
Establish the handle height and mark the door.
Set the latch of the door handle into its hole and make marks to show where the faceplate will be located.
When the door needs to be opened a door handle or sometimes a knob is turned which in turn is attached to the latch via a door bar or door spindle that runs through the latch.
In some cases door latch plate mortises might need to be cut or enlarged.
Chisel out the faceplate so you can install it and screw it into place.
Insert the new latch into the opening with the tapered side facing the direction you will push the door to close it.
Line up the spindle on the back of the handle with the slot in the latch sliding any mechanisms up or down as needed to fit the handle onto the door.
Insert the latch into the side of the door to see if its faceplate sits flush to the door.
Mark your brand new door with the location.
Marking the door handle positions.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
Follow our handy guide to fitting interior door handles.
Tools needed for this job.
The latch plate can now be fitted to the door frame.
Close the door to and mark the centre of the latch tongue on the door frame.
Fitting door handles may appear complicated at first but it is an easier task then you think.
Check that the new latch plate fits the recessed.
Step by step guide to fitting a mortice latch door handles.
If your new door handle attaches to the door at a point below the lower borehole like ours you may need to drill another hole to accommodate.