Designer custom door or drawer panel installation.
How to install panel door on sub zero fridge.
10 reinstall panel assemblies and replace door trim.
States a hazard that may cause serious injury or death if precautions are not followed.
Assembly from door see figure 2.
Loose handle on sub zero custom panel.
Engage the tabbed bracket to the handle side of the door then slide the hinge side mounting bracket onto positioning screws.
700 series panel removal.
See also framed door panel installation instructions.
Slide door panel into door trim frame see figure 2.
Install custom panels on a designer formerly integrated product.
See also sub zero standard and accessory handle information.
Overlay panels must be a minimum of 5 8 thick to support mounting the handle.
To install the custom door panel partially insert a screw in the center of each mounting position on the hinge side of the door.
Pull the trim strip down to pull it out from under the top trim.
Panel mounting brackets for designer units.
Signals a situation where minor injury or product damage may occur if you do not follow instructions.
Refer to the product installation guide for further installation information.
States a hazard that may cause serious injury or death if precautions are not followed.
How to mount or remove panels from designer series doors and drawers.
Refer to the sub zero design guide for design specifications.
Signals a situation.
Grasp the trim on one side of the door near the bottom and pull the trim away from the refrigerator.
If panel is less than 1 4 6 mm thick install chipboard filler panels behind panel.
To install the handle reverse the above steps.
Sub zero stainless steel door handles are typically mounted 1 1 2 from the handle side of the door or top of the drawer.
Framed handle is loose.
Make sure the built in unit is secured in place with anti tip brackets to prevent tipover when panel weight is added to open doors.
With panel in position secure handle assembly to door by reinstalling handle mounting screws see figure 2.