A clean surface increases the bonding strength between the panels and wall.
How to install frp panels without glue on concrete wall.
Apply the adhesive in rows that are 3 to 4 inches apart.
Use a trowel and apply a 1 4 inch thick layer of frp adhesive to the back side of the first panel.
Clips are recommended to.
Fiberglass reinforced panels or frp are thin flexible plastic panels made of strong polyester resin reinforced with fiberglass.
They are used on walls and ceilings and can be installed directly over drywall wood concrete block and many other solid surfaces frp systems include plastic trim molding to create a continuous durable scratch resistant surface that is easy to clean and mold.
This allows moisture to penetrate the seams of the panels causing moisture damage.
This liquid nails 1 gal.
This adhesive is spreadable with a trowel and covers about 50 sq.
Voids between the frp and the wall surface cause the frp to release from the wall.
Before you start your frp panels installation cut your corner moulding.
Fiberglass reinforced plastic panel adhesive is a high strength bonder specifically formulated for bonding frp panels but will also bond non fiberglass reinforced panels nrp.
Insert the panel into the corner moulding.
Because frp conforms to the substrate behind it anything on the wall such as nail heads will show up through the panel.
Insert a tube of adhesive into a caulking gun then cut the tip off with a utility knife to make a 1 4 inch hole.
Cut it to fit the height of the wall apply a bead of silicone caulk down the entire length and press it into the inside corner.
Before installing paneling to a concrete or brick wall first remove all dirt dust and debris from the wall.
Using the proper tools to install cut and drill the frp will keep the wall panels in place.
Apply a layer of adhesive onto the back of the fiberglass sections with the caulking gun.
Fiberlite frp may form and contour to wall surface that are not prepared prior to installation.
Squeeze the tube with the gun as you drag the tip along the back of the fiberglass.