Remove the two screws holding the strike plate in place on the door jamb and install the new one in the same position.
How to install a new front door handle.
Install both knobs by sliding the spindle through the slot in the latch.
Once the door is drilled installation is a simple job.
My front door knob was broken and i couldn t open the door from the inside or outside.
Fasten both with mounting screws.
Align the two long screws from the inside knob into the cylinders on the exterior door knob and tighten the screws.
Fill any screw holes with the wood putty and give it 30 minutes to a few hours to dry depending on the putty instructions.
The handle will stay in place leaving your hands free to secure the interior trim.
Mount the latch and deadbolt into the mortises with two screws each.
Install the inside handle.
Avoid damage to the screws by using a hand screwdriver.
Line up the spindle on the back of the handle with the slot in the latch sliding any mechanisms up or down as needed to fit the handle onto the door.
If so just seal the corner of the cap and don t install the pads.
Then install the handle set according to the instructions aligning the spindle with the latch.
If your new door handle attaches to the door at a point below the lower borehole like ours you may need to drill another hole to accommodate.
Use wood putty to secure any loose screws.
To steady the base of the handle insert a mounting screw and hide its head with the decorative cover supplied.
Install a new door lock and door knob by inserting the latch through the hole for the new parts.
Add the interior lever rotating the chassis tabs so it slips through the latch and easily joins the handle.
Here s how i did it.
Next you ll install the outside handle assembly.
I had to fix it.
Next fit the knob on the spindle and tighten its setscrew.
Here is the handleset i bought.
Slide the adjustable throughbolt up or down as needed and press the handleset onto the door.
Fit the lock over the projecting cylinder post and put the knob s spindle and rosette assembly on the thumb latch post.
Apply caulk to the corners along the edges of the cap then install the self stick corner pads that were included with the door.
Align the spindle on the back of the assembly with the throughbolt and the slot in the latch.