How To Hang Wall Art On Plaster Walls

Wood lath plaster walls that are commonly foun.

How to hang wall art on plaster walls.

Drill a hole the same diameter of the plastic plaster anchor insert if you are hanging in area without a wall stud. You ll know this is happening if the anchor flange starts to depress the surface of the plaster or drywall. Perform the cleaning using warm water and a mild liquid dish soap. For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done.

Turn the screw to mushroom the slotted sleeve against the back wall surface. If your room has this you can simply drive a screw through the wood and use this to hang things. Some older plaster walls have a thin strip of wood that runs around the perimeter of a room usually between 1 inch 2 5 cm to 1 foot 30 cm below the edge of the ceiling. Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail.

Take care not to overtighten. How to hang lightweight pictures on plaster walls. This part will be easier if you have someone to hold the mount up for you. Place the insert in the hole and tap it into the hole with a hammer until the.

If the mount is straight the bubble in the liquid will stay in the center. Press the mount flat against the wall then set the level on top of it. How to use them. Cleaning ensures that there is no oil dirt or moisture that could prevent adhesive glue from clinging to the wall.

Clean and dry the wall. Use a picture rail if you have one. How to hang on plaster walls with a picture hanging system the ideal solution for hanging pictures on plaster is to use a picture hanging system like the all in one click rail cable hanging kit. Check the small capsule of liquid along the center of the level.

To hang a picture on a plaster wall make a pencil mark where you want to hang the picture then cover the mark with a small piece of painter s tape. Use a carpenter s level to level the mount on the wall. Then hammer a wall anchor into the hole until it s flush with the plaster. Seat the round flange flush with the wall surface by tapping the screwhead.

Next drill a hole into the mark using a 3 16 drill bit before removing the piece of tape.