How To Fix Old Garage Door Spring

If the door was closing too quickly move the spring to the next higher hole on the bracket.

How to fix old garage door spring.

If your garage door cable is at an angle or l. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. Disconnect the spring from the track bracket and the spring pulley and disconnect the safety cable from one end. Once the spring is free of tension remove from its track hanger.

If the door remains in place the replacement was a. Retest the door balance as you did in step 1. Open the door to relieve the spring tension and secure it open with c clamps in the tracks. Put on eye.

The general process is simple and safe. Diy garage door repair and save money. Adjust the springs on both sides of the door the same way. Pull the cable as tight as possible before tightening the setscrews.

Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Lubricate the spring with garage door lubricant then remove the clamp from the garage door. Leave the locking pliers in place and repeat the tightening procedure on the other side. Install the new spring reinstall the pulley and reconnect the safety cable and you re done.

Test the spring by lifting the door about 3 feet. This system is unsafe and sh. If it was opening too quickly move it to the next lower hole. Rotate the drum to wind the cable into the winding grooves.

Step 1 unplug the garage door opener and clamp the door to the track. Disconnect the garage door opener so the door remains closed.