How To Fit A New Door Handle

If your new door handle attaches to the door at a point below the lower borehole like ours you may need to drill another hole to accommodate.

How to fit a new door handle.

Measure the diameter of the holes currently cut out of your door so you can select a new door lock that fits those dimensions. First of all decide on an appropriate height for the door handles and mark the centre of the door handle on the edge of the door with a pencil. This post is going to show you how to fit a door handle in 6 simple steps. Using the screws that came with your door handle kit attach the faceplate to the door.

Press in the metal piece in the slot and the doorknob should come loose. How to fit door handles and latch to interior doors. Once you know the steps it s a really simple project to take on. Mark your brand new door with the location.

Follow our handy guide to fitting interior door handles. Be careful to fit the latch into the chiselled area and screw into the pilot holes that were made earlier. These will be either on the cover plate or if not look for a small slot on the side of the handle. Drill the screws carefully being sure to keep your drill level with the floor.

New doorknob or handle. Remove the old door handle or knob. Before you can fit a door handle to a new door you will first need to mark regions to be drilled and cut. Line up the spindle on the back of the handle with the slot in the latch sliding any mechanisms up or down as needed to fit the handle onto the door.

Take care to measure carefully as matching the size can be especially problematic in older homes. Fitting door handles may appear complicated at first but it is an easier task then you think. Before you learn how to change door locks measure the space where you ll install the replacement. First you need to remove the screws holding the existing knob or handle in place.