How To Fit A New Door Handle And Lock

Dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to the color code on the special instruction sheet.

How to fit a new door handle and lock.

Marking the door handle positions. Usually upvc locks are sized and measured using two standard reference points. There are usually no holes on the front and rear sides of the door for the door handle and if required the key. Most ready to use doors from the diy stores have a recess for a lock in the edge.

Mark your brand new door with the location of your handle. Before you can fit a door handle to a new door you will first need to mark regions to be drilled and cut. The distance between the edge of the door and the center of the lock hole. Be careful to fit the latch into the chiselled area and screw into the pilot holes that were made earlier.

Insert the pins and reassemble the lock. Usually the backset measures 2 3 8 inches or 2 3 4 inches. Replacing the lock or handle on a garage door can be accomplished with the appropriate tools. If the new lock body or faceplate is larger than the old use a hammer and wood chisel to enlarge the mortice hole so the new lock fits properly in place.

Step 6 once the lock body is in place screw the faceplate into position. You can fit a standard mortise lock with a sprung latch operated by the door handle and a key operated locking bolt or a security lock. Drill the screws carefully being sure to keep your drill level with the floor. Before purchasing a lock measure your door s backset cross bore and thickness to ensure you find the right fit.

If you have an up and over garage door or a roller lock the lock or handle can easily be changed and replaced. Replace a garage door lock or handle with help from a garage do. Once the new pins are in reverse the steps to reassemble the lock. In general internal door handles are usually positioned at a particular height.