Tapcon 2 3 4 in x 1 4 in concrete anchors.
How to anchor a half wall on concrete.
Hammer the anchor into the hole in the concrete.
Screwed directly into the block for a finished look if using a stud type anchor female type anchor or the concrete screw the fixture or item being fastened can be removed at any time with little or.
Place the two by four in its desired location.
Drill through the stud to make a divot on the concrete.
I nailed it in place and even drove some heavy duty spax screws into it as.
Continue to hammer the anchor down until the nut and washer are tight against the fixture.
How to install concrete wedge anchors.
A hammer drive anchor requires only a small pilot hole.
Drop the anchor into the hole in your fixture and hammer the pin on the top of the anchor to drive it into the concrete hole you drilled earlier.
For pricing and availability.
It should be a fairly tight fit.
The anchors hold the bottom plate very securely and greatly reduced the movement of the wall but i also needed some extra bracing to keep the studs from moving back and forth on the bottom plate.
Tapcon 10 pack 4 in x 3 8 in concrete anchors.
For this i used a couple scrap 2 6 s with 45 degree angles on each end.
For pricing and availability.
Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
Mark the location for the anchor centered on the two by four stud.
Drop in the anchor and hammer on the pin to expand the bottom of the shield against the wall of the hole.