How Do You Lay Roll Roofing

If possible install roll roofing over a smooth plywood deck either perpendicular or parallel to the slope.

How do you lay roll roofing.

The roofing should overhang the eaves by inch except where you install drip edge flashing on top of the roofing along the rake edge. Position the first course so it overhangs the drip edges by about 1 4 inch and roll it out a. How to do it attach first course. Step 3 apply the edge strips.

How to properly install roll roofing. To seal a plumbing vent spread roofing. To install roll roofing you ll need to cut the material into long strips of the correct length for your roof and lay it flat. A gas burner is held so that it warms up the ground surface and the lower surface of the material.

Plan so that no two butt joints are closer than 2 feet from each other. You need to place starter strips of roll roofing along all edges of the roof so start by cutting pieces of roofing about 18 inches wide. The canvas is rolled up into a roll back to the point of attachment. An underlayment of felt roofing is optional.

The strips should always be horizontal. For extra durability you may install roll roofing in two layers. Roll roofing is not very pliant or flexible in cold weather of fewer than 45 degrees fahrenheit and it can crack and break if. Then apply roofing cement evenly around the roof edges where these strips are going to go.

Be careful not to get any on your skin in this process.